Skip to content

FPGA GPIO

Jump to bottom
Hampus Sandberg edited this page Mar 3, 2015 · 1 revision

Input modes

  • Input sampler: Samples the input at the set sampling rate, or if the sampling rate is 0 it will only display the current value and not save to memory

Output modes

  • Normal output: Set it to high or low
  • PWM: Control duty cycle, frequency(prescaler)

General

Homepage
Pictures
GUI Mockup
Contact

Software

--Link to files--

Version 2:
ui-processor-rtos
fpga-config-mcu
fpga-config-over-uart

Version 1:
freertos-serial-monitor
freertos-serial-monitor lcd test

Simple GUI:
General
GUIObject
GUIButton
GUILabel
GUIStaticTextBox
GUIAlertBox
GUIButtonGridBox
GUIButtonList
GUIInfoBox

Tasks:
LCD Task Message

Drivers:
FT5206
MCP9808

Hardware

LCD:
LCD ER-TFT070-4
LCD ER-TFTM070-5
LCD HY070CTP-HD
LCD HY101CTP-HD
LCD YL070MY01
Touch Controller

Measurements:
STM32 GPIO Speed
FT5206 Waveform Capture

Version 2:
Revision 2 Mockup
Module IDs
Boards:
Connection Board
UI Processor Board
Data Processor Board
Isolated Power Module
LCD Board
Modules:
1. GPIO Module
3. CAN Module
5. RS-232 Module
15. nRF24L01 Module
Future Module Ideas
FPGA:
FPGA Main Blocks
FPGA Communication
FPGA UART
FPGA GPIO
FPGA Timestamp
FPGA SDRAM
FPGA PLL
[FPGA ID Reader](https://github.com/hampussandberg/HexConnect/wiki/FPGA-ID Reader)
FPGA LVDS
FPGA Monitor
FPGA Tips and Tricks
Learning Quartus II

Version 1:
Requirement Specification
Hardware Design
Hardware Rev 1 Fixes

Clone this wiki locally