Skip to content

Bringing WiFi to the Cidco Mailstation

License

Notifications You must be signed in to change notification settings

jcs/WiFiStation

Folders and files

NameName
Last commit message
Last commit date

Latest commit

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Repository files navigation

WiFiStation: A WiFi interface to the MailStation

This project is a set of firmware, tools, and hardware specifications for a board housing an ESP8266 module which talks to a Cidco MailStation over its parallel port.

WiFiStation acts as a modem with an AT command interface allowing the MailStation to issue AT commands to "dial" to telnet addresses rather than phone numbers. This allows the MailStation to use software like msTERM to connect to BBSes over WiFi rather than its internal modem.

All communication between the WiFiStation and the MailStation is also echoed on the WiFiStation's USB serial interface, so commands can be sent from a host computer as well.

For the latest documentation for this project, please see my WiFiStation site.

Hardware Details

An MCP23017 MCP23S18 connects to an Adafruit Feather HUZZAH ESP8266 over I2C SPI and has 12 of its GPIO lines (8 data, 2 input status, and 2 output control) routed to pins on a DB25 connector, which plugs into the MailStation's printer port.

The full BOM can be found here.

Compiling and Flashing esp8266 Firmware

On macOS:

Install Arduino GUI and esp8266 board info per these instructions.

$ git clone https://github.com/plerup/makeEspArduino
$ git clone https://github.com/jcs/WiFiStation.git
$ cd WiFiStation/esp8266
WiFiStation/esp8266$ make
- Parsing Arduino configuration files ...
- Finding all involved files for the build ...
[...]
WiFiStation/esp8266$ make upload
=== Using upload port: /dev/tty.usbserial-02331261 @ 115200
esptool.py v3.0
Serial port /dev/tty.usbserial-02331261
Connecting....
Chip is ESP8266EX
Features: WiFi
Crystal is 26MHz
[...]