Ideal config

config.scad

@@ -9,18 +9,20 @@ bushingheight = 24;
 nemasize = 1.7; //Nema Size (in imperial)
 motorcenter = 23; //center hole size for the motor. If your motor center flange is smaller you can beef up parts this way. 
 motorshaftdia = 5; // Motor shaft diameter
-motorcenterwall = 5;
 motorbody = 43;
 
-pulleypitch = 5; //trapezoidal TODO
+pulleypitch = 5; //trapezoidal pulley script TODO
 pulleyteeth = 8;
 
 /* The Mixtape Mendel uses two types of fasteners. One is the "primary" type, which is the larger type that builds the structure,
  which was profiled above as "frameroddia, etc..". In the case of the Mendel, it is M8 threaded rod (Huxley, M6). It also uses "Secondary" hardware. This is a smaller screw used to retain tool heads, attach motors and lock pulleys on shafts. In the case of Mendel this is M3 or M4. M3 is preferred as it is cheaper.
 */
 nutheight = 7; //Primary
-nutdia = 14.8; //Primary
+nutapothem = 13; //Primary
+
 secscrewdia = 4; //secondary 
+secnutapothem = 5.5; //sec
+secnutheight = 2.4; //sec
 
 beltthick = 2; //Thickness of the timing belt
 beltwidth = 6; // Belt width used for the y bed clamps
@@ -33,44 +35,6 @@ bearinginnerrace = 12; // the amount of the inner race diameter exposed
 
 layerheight = 0.32; //skeinforge/slicer layer height, used for the idler wasers right now. 
 
-//Beef/tab/wall
-motortabwall = 2.5;
-
-//Frame Vertex
-vertexwall = 3;
-triangle = 60; // the angle the bottom vertexes have relative to horizontal
-
-//Y Motor Mount
-ymountthick = 9;
-ywallmulti = 2; //the wall thickness multiplier for the bits that interface with the frame rod
-
-//Y Belt Clamps
-clampholewall = 3;
-	//(bushingod-pulleydia)/2
-
-//Top Piece
-toppiecethick = 8;
-toprodwall = 4;
-toprodspacing = 72;
-siderodwall = 4;
-
-// X End Pieces
-xrodspacing = 50; //rod spacing center to center
-nutwall = 3; //wall thickness around nut and bushing
-towergap= 10; // 0.75 diameter wrap should be ok i think. Make a flag for full wrap and no square for bushings/linear bearings maybe?
-
-//X Carriage 
-carriagewidth = 50;
-tooldia = 17;
-platformthick = 7;
-platformextension = 40; 
-
-//Z Coupler 
-//TODO - Redesign
-//couplerwall = 4;
-//couplerheight = 34; // Make this double 3/4 your shaft length
-
-//Extruder (Plastic Pusher)
 bowdencabledia = 4;
 pinchwheeldia = 8;