BUG: HS102 Pro Channel 2 AC/DC selection on reconnect

[gadjex]

On an HS102 Pro, after turning on channel 2 to DC mode and then disconnecting the USB and reconnecting, the app will erroneously show DC mode on channel 2 when it is actually in AC mode. Switching channel 2 off and then back to DC mode will fix the issue until the next disconnect and
reconnect.

This is confirmed by using a volt meter and checking pin PB13 is at 0 volts after reconnecting.

Channel 1 does not display this improper behavior.

[martinloren]

Thanks for reporting this issue. What is the firmware version?

[gadjex]

Happens with v9 and v10.1

…

On Fri, Jun 19, 2020, 4:18 AM Martin Loren ***@***.***> wrote: Thanks for reporting this issue. What is the firmware version? — You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub <#33 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ABTDKLCT46CSCH7OWMUNTBTRXMNOLANCNFSM4N6TQSMA> .

[martinloren]

Confirmed, it is a bug on HScope, it will be fixed in next Beta release. By the way there is no documentation for the HS102 Pro but the firmware is working probably....did you build it? I mean with the PGA and all range of input voltages or just single voltage range?

[gadjex]

I built it with 2 PGAs 2 SSRs and 2 AMS1117. Both channels work +-15V. I haven't fully tested it. I can send you the schematic when I get home tomorrow. It really is just a HS101 Pro with a duplicate channel.

…

On Fri, Jun 19, 2020, 12:46 PM Martin Loren ***@***.***> wrote: Confirmed, it is a bug on HScope, it will be fixed in next Beta release. By the way there is no HS102 Pro....did you build it? I mean with the PGA and all range of input voltages or just single voltage range? — You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub <#33 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ABTDKLB66QSEQQJL7ACJ4F3RXOI5XANCNFSM4N6TQSMA> .

[martinloren]

This issue should have been solved in the latest HScope release.