Bridge Interface Error - Failed to query interface 'br0'

[dR3b]

Describe the issue

The network interface "br0" is not displayed. But it works with a physical network adapter e.g. "eno1".

To Reproduce

A minimal but complete config with which the problem occurs:

modules-right = network

[module/network]
type = internal/network
interface = "br0"
label-connected = "%ifname% %linkspeed%"
label-disconnected = disconnected

Polybar Log

Post everything polybar outputs to the terminal when you run it and the issue occurs below

warn: module/network: Failed to query interface 'br0'
warn: module/network: Failed to query interface 'br0'
warn: module/network: Failed to query interface 'br0'
warn: module/network: Failed to query interface 'br0'
warn: module/network: Failed to query interface 'br0'

Environment:

• WM: i3
• PB: polybar 3.2.1

[patrick96]

Hmm, I don't even know if polybar was built to support bridge interfaces.

Can you run the following commands for me so that I can figure out, if the current implementation can support bridge interfaces.

ethtool -i br0
ethtool br0
cat /sys/class/net/br0/operstate

[spsarolkar]

Hi,

I am facing the similar issue,

below is output of commands mentioned above

$ cat /sys/class/net/br0/operstate
up
$ ethtool br0
Settings for br0:
Cannot get wake-on-lan settings: Operation not permitted
Link detected: yes
$ sudo ethtool br0
Password:
Settings for br0:
Link detected: yes

[dR3b]

cat /sys/class/net/br0/operstate
up

[dR3b]

Thanks!