It is possible to update with new orginal firmware from FlySky 20-Sep-2019 ?

[macem]

It is possible to update with new orginal firmware from FlySky 20-Sep-2019 ?

[DG9BFC]

i have updated to 23-oct-2019
from clerik
https://github.com/Cleric-K/FlySky-i6X_Firmware_BugFix
but that only supports 10 channels
what i like is the much smother curve on all channels so what i woul like to have is be to merge both fw versions (from qba667 and from clerik-K) in ONE version that has all bings and boings
but i am not a programmer and have no idea how to merge both in one :-(
greetz sigi dg9bfc

[jakeeri]

You should look at this instead https://github.com/OpenI6X/opentx
It is continued work from where qba667 left off. It's a fork of OpenTX and has all the bells and whistles.

[DG9BFC]

i could flash that open tx fw on my i6x BUT how can i assign swirches and channels (also the vr1 and vr22) ... how to setup mixers??
in the oct fw (that was close to the original but with that smooter curves) the "user interface" was much easier in my view
where in the open tx fw are those settings made?!?
setup of switches, flight modes (stabilized 1;2 and 3), dual rate (sport and normal), idle up etc etc
how to programm a mixer from one channel to another?!?
that new fw seems to have a lot of bings and boings but the user interface is too complicated in my view ...
(at least if you are new on that fw)
is there something like a user manual for that heavy modded (or better say completely written new) fw??
the wiki says how to flash and not that much more :-(
but thanks anyway for the hint ... al least i learned a lot whil doing the modding/hacking
hopefully i can get a bit of help in the telegram group
greetz sigi dg9bfc

[jakeeri]

Look at https://www.open-tx.org
Also search rc video reviews channel from youtube, lot of tutorials there.

[DG9BFC]

Very high learning curve... But i will try to figure it outGreetz sigiAm 06.06.2022 16:09 schrieb jakeeri ***@***.***>: Look at https://www.open-tx.org Also search rc video reviews channel from youtube, lot of tutorials there. —Reply to this email directly, view it on GitHub, or unsubscribe.You are receiving this because you commented.Message ID: ***@***.***>