You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
During my build I was struggling with how the spur gear axis is "connected" to the motorblock. Intuitively, I wanted to fit a second, bigger bearing into that hole but my 5x16x5mm bearings I have left from my printers just would not fit. And it is not in the design files either - on purpose?
Anyway, I am going to adjust the design and increase the inner hole by 1mm to 16. Dunno if it is a bug or not intended to contain a bearing, but I will try it anyway. I think it relieves some pressure from the small bearing next to it.
The text was updated successfully, but these errors were encountered:
yes, that hole was not intended to contain a bearing. Its size was an arbitrary choice just to make some room for the spur gear.
sometimes the spur gear goes in like that:
During my build I was struggling with how the spur gear axis is "connected" to the motorblock. Intuitively, I wanted to fit a second, bigger bearing into that hole but my 5x16x5mm bearings I have left from my printers just would not fit. And it is not in the design files either - on purpose?
Anyway, I am going to adjust the design and increase the inner hole by 1mm to 16. Dunno if it is a bug or not intended to contain a bearing, but I will try it anyway. I think it relieves some pressure from the small bearing next to it.
The text was updated successfully, but these errors were encountered: