PlatformIO : UPLOADING ERROR #123
FallcorpIndustries
started this conversation in
General
Replies: 1 comment
-
I resolve it I opened the Com5 else where to monitor pio device monitor |
Beta Was this translation helpful? Give feedback.
0 replies
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
I was following the installation process but every time I try to upload it says this below
Using Visual studio
Open the project in a new window. Run the following tasks using the Terminal -> Run Task or CTRL+ALT+T command in the menu (or use the icons below on the toolbar). Make sure the ESP32-CAM is in download mode during the uploads.
PlatformIO: Build (esp32cam)
PlatformIO: Upload (esp32cam)
To monitor the behavior run the task, run: PlatformIO: Monitor (esp32cam)
Working on ESP32 cam Ai thinker
Processing esp32cam_ai_thinker (board: esp32cam_ai_thinker; platform: espressif32; framework: arduino)
Verbose mode can be enabled via
-v, --verbose
optionCONFIGURATION: https://docs.platformio.org/page/boards/espressif32/esp32cam_ai_thinker.html
PLATFORM: Espressif 32 (6.6.0) > ESP32CAM AI Thinker
HARDWARE: ESP32 240MHz, 320KB RAM, 4MB Flash
DEBUG: Current (cmsis-dap) External (cmsis-dap, esp-bridge, esp-prog, iot-bus-jtag, jlink, minimodule, olimex-arm-usb-ocd, olimex-arm-usb-ocd-h, olimex-arm-usb-tiny-h, olimex-jtag-tiny, tumpa)
PACKAGES:
LDF: Library Dependency Finder -> https://bit.ly/configure-pio-ldf
LDF Modes: Finder ~ chain, Compatibility ~ soft
Found 38 compatible libraries
Scanning dependencies...
Dependency Graph
|-- IotWebConf @ 3.2.1
|-- Micro-RTSP @ 0.1.6
|-- micro-moustache @ 1.0.1
|-- ESPmDNS @ 2.0.0
|-- RTSPServer @ 1.0.0
Building in release mode
Retrieving maximum program size .pio\build\esp32cam_ai_thinker\firmware.elf
Checking size .pio\build\esp32cam_ai_thinker\firmware.elf
Advanced Memory Usage is available via "PlatformIO Home > Project Inspect"
RAM: [=== ] 26.0% (used 85180 bytes from 327680 bytes)
Flash: [===== ] 52.4% (used 1030405 bytes from 1966080 bytes)
Configuring upload protocol...
AVAILABLE: cmsis-dap, esp-bridge, esp-prog, espota, esptool, iot-bus-jtag, jlink, minimodule, olimex-arm-usb-ocd, olimex-arm-usb-ocd-h, olimex-arm-usb-tiny-h, olimex-jtag-tiny, tumpa
CURRENT: upload_protocol = esptool
Looking for upload port...
Auto-detected: COM5
Uploading .pio\build\esp32cam_ai_thinker\firmware.bin
esptool.py v4.5.1
Serial port COM5
A fatal error occurred: Could not open COM5, the port doesn't exist
*** [upload] Error 2
Beta Was this translation helpful? Give feedback.
All reactions