You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Navigating multi-byte characters is "wrong" on REPL. Without telling you the actual behavior, I'd like if you try doing the following. Fix the errors in this statement- System.out.println( Seq( "允走 ) ) ).
You will notice that when you're on the Unihan characters, you'll have to do Ctrl-F/right arrow twice for the cursor to seem to move forward. However, the actual movements registered 4 such forward characters (2 times for each Unihan), so the cursor may show up right after the second Unihan character but you're actually two places forward from there. Needless to say it's a "wrong" behavior and can be annoying.
This could likely be an issue with jline, or the terminal software itself too.
The text was updated successfully, but these errors were encountered:
I've tried the
Navigating multi-byte characters is "wrong" on REPL. Without telling you the actual behavior, I'd like if you try doing the following. Fix the errors in this statement-
System.out.println( Seq( "允走 ) ) )
.You will notice that when you're on the Unihan characters, you'll have to do Ctrl-F/right arrow twice for the cursor to seem to move forward. However, the actual movements registered 4 such forward characters (2 times for each Unihan), so the cursor may show up right after the second Unihan character but you're actually two places forward from there. Needless to say it's a "wrong" behavior and can be annoying.
This could likely be an issue with jline, or the terminal software itself too.
The text was updated successfully, but these errors were encountered: