-
Notifications
You must be signed in to change notification settings - Fork 0
minitiger Touch Light Switch
This is a cheap Sonoff T1 clone. Available with 1/2/3 channels.
The board has the ID 2PH89174A
- ESP8285 micro
- Blue status LED (micro controlled)
- Separate touch IC controlled switch status indicators (blue and red)
- Aliexpress link: Click
Front and soldering: Fullsize
Front and identification number: Fullsize
Back and GND: Fullsize
Soldering layout: Fullsize
This board can be flashed with vanilla sonoff-tasmota. I used esptool on linux to upload the firmware.
Short GPIO0 to GND, as with all boards.
If you have successfully put the micro into programming mode the LED does not light up!
Works out of the box, configured as Sonoff Basic. The LED does not light up when the switch is turned off. Configure as Sonoff T1 to enable the LED.
{"NAME":"Wall Switch 2C","GPIO":[17,255,255,255,0,22,18,0,21,56,0,0,0],"FLAG":0,"BASE":28}
Since I don't own such a board, you are on your own...
Button 3 should be GPIO10 and Relay 3 should be GPIO4. Use at your own risk!
Home
What's New
Contributing
Installation
Prerequisites
Hardware Preparation
Flashing
Initial Configuration
MQTT
Upgrading
Troubleshooting
Tutorials
FAQ
Features
Commands
Templates
Modules
Components
Rules
Smart Home Integrations
Device Configuration
Templates Repository
Flashing Guides
Buttons and Switches
Status LEDs
Sensors
Lights
Displays
Useful Topics
Power Monitoring Calibration
MQTT Overview
MQTT Retained Messages
Energy Saving
Securing Your Setup
Syslog Setup
Theo's Tips
Various Tips
LEGO Nightstand Switch
For Developers
JSON Status Responses
Sensor API
Time Proportioned Output Fork
PID Control Fork