-
Notifications
You must be signed in to change notification settings - Fork 0
LC Technology WiFi Relay
In order to use LC Technology WiFi Relay for 1 relay version, please
- Set module to Generic (in module configuration and click save)
- Set i.e. GPIO12 as Relay1 (in module configuration and click save)
- Disable seriallog (type
seriallog 0
in the tasmota console) - Enable rules (type
rule1 1
in the tasmota console) - Add the following rules typing in the console:
Rule1 on System#Boot do Baudrate 9600 endon on Power1#State=1 do SerialSend5 A00101A2 endon on Power1#State=0 do SerialSend5 A00100A1 endon
- Note: If that doesn't work for you, you may find that using Power1#Boot as the event to trigger the baudrate setting (instead of System#Boot) works, as it did for me. So the alternate rule one command is..
on Power1#Boot do Baudrate 9600 endon on Power1#State=1 do SerialSend5 A00101A2 endon on Power1#State=0 do SerialSend5 A00100A1 endon
LC Technology WiFi Relay - Dual Relay (note, older versions of this board used a baud rate of 9600, so if 115200 doesn't work, try 9600)
To configure an LC Technology ESP8266 Relay X2, use the following settings...
- Set module to Generic (in module configuration and click save)
- Set GPIO0 and GPIO2 as Relay1 and Relay 2 (in module configuration and click save)
- Disable seriallog (type
seriallog 0
in the tasmota console) - Enable rule1 (type
rule1 1
in the tasmota console) - Enable rule2 (type
rule2 1
in the tasmota console) - Add the following rules typing in the console:
Rule1 on System#Boot do Baudrate 9600 endon on Power1#State=1 do SerialSend5 A00101A2 endon on Power1#State=0 do SerialSend5 A00100A1 endon
Rule2 on Power2#State=1 do SerialSend5 A00201A3 endon on Power2#State=0 do SerialSend5 A00200A2 endon
If your board just continuously flashes its led when powered on and no esp-01 is entered, the onboard STC15F104W needs to be programmed! For more details see https://www.esp8266.com/viewtopic.php?f=160&t=13164&start=68#p74262
Additionally once programmed, you may also have to remove r4, some issues exist where r3 and r4 are swapped, but just removing r4 works.
Home
What's New
Contributing
Installation
Prerequisites
Hardware Preparation
Flashing
Initial Configuration
MQTT
Upgrading
Troubleshooting
Tutorials
FAQ
Features
Commands
Templates
Modules
Components
Rules
Smart Home Integrations
Device Configuration
Templates Repository
Flashing Guides
Buttons and Switches
Status LEDs
Sensors
Lights
Displays
Useful Topics
Power Monitoring Calibration
MQTT Overview
MQTT Retained Messages
Energy Saving
Securing Your Setup
Syslog Setup
Theo's Tips
Various Tips
LEGO Nightstand Switch
For Developers
JSON Status Responses
Sensor API
Time Proportioned Output Fork
PID Control Fork