Building Boost Libraries

I always forget the proper way to do so. Below is a post detailing how to build all of the libraries, which takes some time, but it is handy to have them all pre-built.

https://codeyarns.com/2014/06/06/how-to-build-boost-using-visual-studio/

Attached the post contents in case the link goes dead.

Addendum: I had to add the following flag in order to build static libraries that did not also require DLLs in VS2015:

link=static

for a complete command of

b2 link=static toolset=msvc-14.0 --build-type=complete --abbreviate-paths architecture=x86 address-model=64 install -j4
b2 link=static toolset=msvc-14.0 --build-type=complete --abbreviate-paths architecture=x86 address-model=32 install -j4

---

How to build Boost using Visual Studio

If your code compiled with Visual Studio needs Boost, you can get pre-built Boost libraries. However, if your code needs to link with Boost library files, then the Visual Studio version used for your code and used to build Boost has to match. If you cannot find a prebuilt Boost library matching your Visual Studio then you might have to build Boost by yourself.

I had this problem since my code was using C++11 features that required Visual Studio 2015, but the prebuilt Boost libraries were only available for Visual Studio 2012.

To build Boost for Visual Studio, I followed these steps:

• Download the source of Boost from here. Unzip it anywhere.
• Open the Developer Command Prompt for Visual Studio. Change to the directory where Boost is unzipped.
• Build the Boost.Build tool (b2.exe) using this command:

> bootstrap.bat

• Build Boost using this compile invocation:

> b2 toolset=msvc-14.0 --build-type=complete --abbreviate-paths architecture=x86 address-model=64 install -j4

toolset: Use this to specify the Visual C++ compiler to use. For Visual Studio 2015, this is msvc-14.0. For other versions of Visual Studio see this post.

architecture: This is the processor architecture. Keep this x86 for both 32-bit and 64-bit builds!

address-model: Use this to specify whether you want 32 or 64 bit library to be built.

-j: Use this to specify how many cores to use for parallel compilation.

• This compilation took about 30 minutes and after it is done, the Boost header files and built libraries are dumped in C:\Boost. Note: Detailed steps to build Boost for Visual Studio can be found in this StackOverflow post.

Tried with: Boost 1.59, Visual Studio 2015 and Windows 7 x64