You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Hi,
The beacons are not showing up in the android app when i disconnect them from my laptop and supply external power.
The lights go on when i set the module to enable beacon mode (AT+CWSAPEN), however they go off when powered off and don't come back on until I type the above command again.
Am I missing something here?
The text was updated successfully, but these errors were encountered:
This is the intended operation. This firmware is designed this way for use with the SubPos Node boards to reduce flash write wearout. If you just want a basic setup, you can use the standard AT firmware from espressif.
I have updated the readme to reflect this.
Unfortunately there is no quick and easy way to modify the code to work otherwise, as it is using a packet buffer for use with the beacon generator, which you would need to populate from flash.
Hi,
The beacons are not showing up in the android app when i disconnect them from my laptop and supply external power.
The lights go on when i set the module to enable beacon mode (AT+CWSAPEN), however they go off when powered off and don't come back on until I type the above command again.
Am I missing something here?
The text was updated successfully, but these errors were encountered: