Phodal's Smart Home Setup Guide:HomeBridge + Home Assistant + Amazon Echo
-
Updated
Aug 11, 2017 - C++
Home Assistant is an open source home automation system that puts local control and privacy first. It is powered by a worldwide community of tinkerers and DIY enthusiasts, perfectly suited to run on a Raspberry Pi or a local server.
Phodal's Smart Home Setup Guide:HomeBridge + Home Assistant + Amazon Echo
A variety of sensors and actuators connected to the famous ESP8266 and communicating via MQTT. Webserver configuration for WiFi MQTT and sensor/actuator parameters
An alternative firmware for Sonoff devices.
Firmware for ESP8266 based itead Sonoff switches for use with HomeAssistant / mqtt
Using an ESP8266 chip and a DHT shield to send temperature, humidity and heat index info over MQTT
🎛 SwitchKit adds Home Automation to your existing light switches, with a little bit of smarts.
various usefull/useless WiFi MQTT devices hooked up to Node Red and Home Assistant
ESP8266 MQTT PIR Sensor. Compatible with Home Assistant's MQTT sensor and binary_sensor
ESP8266 based 433Mhz transmitter, controlled via MQTT
MQTT Temperature and Humidity sensors
Simple ESP32 LED controller for WS2812(B)/WS2813 strips using MQTT and Home Assistant auto discovery
a rotary encoder connected to MQTT able to control color and brightness of Smart lights
Mysensors Arduino module for controlling the heating and the heater fuel level at home
An MQTT sensor module. Supports DHT sensors and LDR sensors so far
ESP32 digital lights with discovery, speed, multiple effects etc.
Home Assistant config.yaml and Arduino sketch for Addressable LEDs
quick and dirty arduino softswitch using homie-esp8266 that supports on/off or a 'toggle' event.
📦 IoT Room Cube project for ESP