Gore 1A Bumper Pull Front Ramp Horse Trailer

Regular 6’ width (NOT doing extra width)

Tall Back Doors with 15" X 22" Sliding Window w/ Bars in each door w/ Dual Cam Latch

Ramp Over Back Doors (similar to the Kentucky Special)

Two appropriate levels for Butt/Breast Bar attachments (large pony ~14hh , horse ~15-16hh)

go to: ST225/75R15 (8-Ply) in place of ST205/75R15 (6-Ply)

Aluminum wheels (including spare)

Additional interior and exterior lights as recommended

Airflow tubular shoulder area on middle divider

Add tubular head divider. Confirm that this will un-pin and swing towards the ramp to let the drivers side horse get out?

Triangle feed bags for both sides attached to head divider and walls

Torflex Axle in place of Leaf Spring - No Charge

Breast bar or chain across the escape door (similar to what is across the ramp)

Confirm that there is a structural vertical stud in the drivers side wall above the long bus type window so that I can bolt through it to attach a Hi-Tie . Add one both sides if not.

pre-wire for 12v power (Hot when plugged into vehicle and running lights on) for cameras middle front up in the nose in horse area, middle back outside for backup camera

hanging rubber divider.

Cargo hooks (recess) — inside on curb side wall to secure hay bales in empty stall. Must be smooth and horse safe in case stall does get used. Is this possible?

Equalizer brackets on tongue

Full width butt bar for use if the divider is removed. This? One Piece Spring Loaded Butt or Breast Bar at back to keep horse in w/ No back tack

include a Sapphire Blue or Stellar Blue stripe if possible. all black stripes or whatever you normally do is also fine.