You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Hi friend. I tried to make my bluePill board as CMSIS-DAP debug programmer for GD chips. I built Keil project. Downloaded it with ST-LINK Utility. And in devices I see the board now as:
And in Options for target project i set this:
It just doesn't see the board as the programmer:
But, sometimes if I don't set SWJ check box, it does show its Serial No and FW. But only once:
Only I close and open again this window, nothing works. Any ideas how to fix that? Thanks for any help.
But as the device Windows 10 says: All works fine.
I use: Keil V 5.36.0.0.
Windows 10.
STM discovery board (ST-Link) as the programmer for blue pill.
The text was updated successfully, but these errors were encountered:
Hi friend. I tried to make my bluePill board as CMSIS-DAP debug programmer for GD chips. I built Keil project. Downloaded it with ST-LINK Utility. And in devices I see the board now as:
And in Options for target project i set this:
It just doesn't see the board as the programmer:
But, sometimes if I don't set SWJ check box, it does show its Serial No and FW. But only once:
Only I close and open again this window, nothing works. Any ideas how to fix that? Thanks for any help.
But as the device Windows 10 says: All works fine.
I use: Keil V 5.36.0.0.
Windows 10.
STM discovery board (ST-Link) as the programmer for blue pill.
The text was updated successfully, but these errors were encountered: