-
-
Notifications
You must be signed in to change notification settings - Fork 21
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
PoE powered UZG-01 does not come online after reboot #44
Comments
Please provide additional information about the hardware version of UZG-01 (label on the bottom). |
Ok. No need. I'll check and come back. |
You could try to change |
Didn't help at all. I turned of power on the switchport and powered up the UZG-01 via USB-cable instead. The network port just blinked as before until I unplugged the usb cable, waited 10 seconds, and replugged it. This is becoming the most unstable piece of hardware I have purchased for a long time. Not possible to reboot without hassle |
I have the same issue with UZG-01 (POE-0.4) |
Let's separate Zigbee and ESP issues. I will look for some solution to made ESP32 works with LAN port more stable. |
You could try to change "pwrAltPin": 5, to "pwrAltPin": -1, in your configHW.json. Have you? |
It hasn't helped |
@mercenaruss could you help us ? |
I have the same issue on a UZG-POE-0.5. It doesn't always survive a reboot and am left with the NIC lights pulsing off and on again 3 times in a cycle. I have 2 of these devices, i think both with the same Hardware revisions based on the Status page (ESP32-D0WD-V3) and the sticker on the bottom (UZG-POE-0.5) but only one of them has this issue. I reboot the other one on a daily basis to install all the new firmware updates and it always reboots fine with no issues. (Just as well really as that one is in a remote site!) Happy to try any suggestions to help pinpoint the issue. |
@tonius7570 @zoptooniek Try to change "pwrAltPin": -1, to "pwrAltPin": -1, in your configHW.json. |
@mercenaruss changing this made no difference to me. I'm still in the same situation. |
Could you try factory reset after updating to 20240607* ? |
This seems to have done the trick so far. |
@zoptooniek could you check it later to confirm, and if no issues - close this issue ? |
@xyzroe - Performed a few more reboots and fw updates and all seems good! |
Not sure if this is related to the switch or the UZG-01
If I restart the UZG-01, it does not come back until I shutdown the switchport and turn it back on.
Until then, the UZG network port blinks for a second, then goes dark. Blinks for a second then goes dark, etc.
The switch is a Cisco Catalyst 9300 of model C9300L-48UXG-4X
The port settings looks like this:
The show power inline command shows this:
The configHW.json debug file contains this:
The text was updated successfully, but these errors were encountered: