You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Still scrolls incorrectly for me - just tested it.
** New info: Hitting the rescan button makes the scrolling behave
correctly. It still does not scroll correctly on first entering the app.
The rescan workaround is good enough for me.
Running on firmware 1.0.2. Using version 0.04.1189413695 installed via
AppTapp Installer. Launching the app via SummerBoard.
I have 13 wifi networks in my immediate area. 3 are open and 10 protected.
When I open Stumbler, the 3 networks are shown in the top under the "Open"
header. The "Protected" header shows underneath with the first three
networks in that group.
If I flick the screen upward, it scrolls into the Protected group, but then
immediate springs back down so that half of the "Open" header is showing
(with no entries) with the "Protected" header and its entries immediately
below it.
Dragging the screen upward gives a similar result - as soon as I release
the screen, it immediately springs back down so that the "Open" header is
partially showing.
Because of this behavior, I can only see the first 6 protected networks
unless I hit rescan.
Original issue reported on code.google.com by roger.a....@gmail.com on 21 Sep 2007 at 8:51
The text was updated successfully, but these errors were encountered:
Ok, definately sounds like a code bug - I usually don't get any networks on
first
entering the app, so I didn't notice it.
For now, rescan is the recommended resolution, however the next version should
have
this fixed.
Thanks
Original comment by lok...@gmail.com on 21 Sep 2007 at 8:56
Original issue reported on code.google.com by
roger.a....@gmail.com
on 21 Sep 2007 at 8:51The text was updated successfully, but these errors were encountered: