Hole Test

Test part to analyse the best hole offset to use in the conception of your parts.

Hole Test

Licence for the Hole Test: CC BY-SA 3.0, magramo https://www.thingiverse.com/thing:2380801

Hole diameter

 1 mm ~ 15 mm

Printing Conditions

 - Nozzle Size : 0.4
 - Layer Height : 0.2
 - Initial Layer Height : 0.2
 - Line Width : 0.4
 - Wall Line Count : 3
 - Fill Gaps Between Walls (Only for release of Cura previous to V5) : Nowhere

Printing Time = 35 mn

Instructions

Print the test part. With a Caliper controle the hole diameter. If you think these values are not correct, you can use the Hole Horizontal Expansion parameter to set the right offset on the holes. In this case we recommend to use the Calibration Cube XYZ or MultiCube test part to verify that the axis are well calibrated via the Horizontal Expansion.

Calibration-Shapes Plugin On Ultimaker Marketplace