WARNING! THE NEW V1.1 VERSION DOES NOT WORK WITH OLDER VERSIONS AND WILL CAUSE DAMAGE TO COMPONENTS IF USED WITH OLDER VERSIONS
Look at it on the PCBWay 5th PCB Design Contest! https://www.pcbway.com/project/shareproject/Wire2Hotend_c0da10a6.html
Are you tired of trying to run 20 wires through a cable sleeve? Do you want to swap things without pulling the motherboard cover off? Well, search no more! This simplifies all 20 wires into one micro fit cable from molex.
Support- up to 70W heaters. 1 Hotend, 2 part cooling fans, 1 heater, support for ender machines. Works with any printer with proper mounts.
Mounts can be found here https://www.printables.com/model/212304-wire2hotend
4040 Mount
Extruder Mount
Photo Collection
Currently only supporting Creality bowden machines, however doesn't support the actual bowden. Must use direct drive, since one mount attaches to where the extruder mounts.
PLEASE NOTE: This project is provided AS IS, and is in active development. This may not work, please make at your own risk. It should work though, nothing is guaranteed.
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
