RRF 3.4.0 config for my custom Railcore II ZL
Hardware:
-Duet 3 6HC mainboard
-Nema 23 stepper on X/Y
-Orbiter V2 extruder
-Mosquito Magnum Hot end
Use at your own risks
Main Features:
-X/Y Nema 23 steppers in D3 with Stealthchop deactivated through coolstep (M915 T parameter) for normal operation >>> Runs in spreadcycle mode for fast normal operation
-Stealthchop manually enabled/disabled with the /Speed folder macro. Speed limited to 65mm/s in stealthchop
-TMC 5160 calibration sequence in the homing scripts
-Startup sequence macro to launch initial G28/32
-start.g calling to conditional G28 (G828) and G32 (G832) only if homing and mesh hasn't been executed already
-No disable steppers in stop.g; enables keeping the homing to launch the next print right away
-Physical front buttons for loading, unloading filament, adjusting Z offset, turning LED on/off...