Firmware for the MakerGear M3.

Built on the orginal Marlin Firmware https://github.com/MarlinFirmware/Marlin

Branch Information

This branch (master) is for M3SE Rev0 and M3ID Rev0

For M3SE Rev1 and M3IS REV1 see branch (1.1.6) https://github.com/MakerGear/m3firmware/tree/1.1.6

Firmware Configuration

Before you can compile, you must select your 3D printer configruation by renaming the correct configuration file.

For The M3SE rename

Configuration_makergear.h.m3SE

to

Configuration_makergear.h

For The M3ID rename

Configuration_makergear.h.m3ID

to

Configuration_makergear.h

Building and Uploading

This firmware has been tested with the commandline version of PlatformIO

http://platformio.org/

It has not been tested with the latest version of the Arduino IDE, though there are no changes that should cause any conflicts. We reccomend you try Arduino 1.8 or higher.