Version 3.4.5 Config C

[Modix3D]

This released is aimed to clean up some bugs and mistakes in the previous case, and catch some edge-case failures

Ease of access changes:

• All files have been pre-seeded with heightmap and PID tuning values, this will help with the calibration setup process
• bed.g file has been split up in two variants, the printer will automatically use the correct variant based on your config.g
  -- bed_duet.g ; For the tilt calibration on Duet only printers
  -- bed_duex.g ; For the tilt calibration on Duex enabled printers.
• Updated rehome, sleep and stop files to detect single or dual-extruder setups
• Added a check for single or dual extruder setups in the rehome, sleep and stop files

Bugfixes:

• Removed deprecated code from homing files, mesh.g, and bed.g files (M280 P0 S60 I1 -> M280 P0 S60)

Other:

• Changed the order of operations in the resume.g to first go to Z+5, then XY position, then back to the previous Z position. This fixes an edge-case where homing the Z axis would result in a crash
• Config.g now has some extra parameters that are used in some other files to check on what code to execute.

---

This discussion was created from the release Version 3.4.5 Config C.