port conneting problem

[ghost]

Hello! It's good material. thank you for making it.

anyway I'm using MATLAB R2016a on windows 10 and using Dynamixel MX-28.

I have a problem that failed to open the port with matlab.

whenever I run this program, it doesn't work with "Failed to open the port!"

however the dynamixel is normally connected to Dynamixel Wizard Roboplus.

also, I checked the comport number and edited it on mfile(read_write.m) of protocol1.0.

I want know why it doesn't work.

if you let me know, I will really appreciate it.

[LeonJung]

Hi,

Sorry for the inconvenience.

Would you check if your com port number is over 10?

[ghost]

Hello! My com port number is 10. Is it any problem?

[LeonJung]

Ok, let's try to change the com port number to under 10 through the device manager -> select the com port which points out your USB device , then go properties -> port settings -> advanced settings -> select another com port number, then click ok.

It must be worked well.

Let me know the result

[ghost]

wow! that's it! as you said, It works very well. I'm sorry I had a lot of question during the evening. Thanks for telling me the solution. 2017-01-11 21:00 GMT+09:00 Leon <notifications@github.com>:

…

Ok, let's try to change the com port number to under then 10 through the device manager -> select the com port which points out your USB device , then go properties -> port settings -> advanced settings -> select another com port number, then click ok. It must be worked well. — You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub <#45 (comment)>, or mute the thread <https://github.com/notifications/unsubscribe-auth/AX5NPsw-4Dg4hsT_YsRqWxta1tSzUr1sks5rRMR6gaJpZM4LgbvA> .