"No data" issue on Sapphire Plus

[Beeblebrox17]

Hello!
I have tried compiling the binaries myself. When that didn't work, I tried the prcompiled binaries from the "release" section. I always encounter the following issue:
The booting starts, and then the display calibration shows up. Then buttons appear, but they all simply carry the lable "No data".
Could you give me any assistance as to what might be the cause?
Thank you!
Micha

[RolfZuckowskiUltras]

Confirmed.

Solution: The GuI is loaded over the assets folder. When compiling yourself via PIO, you are getting your output in the folder .pio/mks_robin_nano35

There is a folder called /assets/. That one contains the GuI. The firmware is located in the file Robin_nano35.bin. Just pull them onto your SD-Card and Reboot the printer. Precompiled Binaries will be fixed.

[RolfZuckowskiUltras]

BTW: They must have changed it or this was just me beeing blind :-)