(supports all 6000+ coins/currencies listed on CoinGecko)
A Python3 ePaper Cryptocurrency price ticker that runs on a Raspberry Pi connected to a Waveshare 2.7 inch monochrome ePaper display. The script periodically (every 5 mins by default) takes data from CoinGecko and prints a summary to the ePaper.
A few minutes work gives you a desk ornament that will tastefully monitor a coin's journey moonward.
(These instructions assume that your Raspberry Pi is already connected to the Internet, happily running pip and has Python3 installed)
If you are running the Pi headless, connect to your Raspberry Pi using ssh.
Install the Waveshare Python module following the instructions on their Wiki under the tab Hardware/Software setup.
(To install the waveshare_epd python module, you need to run the setup file in their repository - also, be sure not to install Jetson libraries on a Pi)
cd e-Paper/RaspberryPi_JetsonNano/python
sudo python3 setup.py install
Copy the files from this repository onto the Pi, or clone using:
cd ~
git clone https://github.com/llvllch/btcticker.git
cd btcticker
Install the required modules using pip:
python3 -m pip install -r requirements.txt
If you'd like the script to persist once you close the session, use screen.
Start a screen session:
screen bash
Run the script using:
python3 btcticker.py
Detatch from the screen session using CTRL-A followed by CTRL-D
The ticker will now pull data every 10 minutes and update the display.
The ePaper is slow. There is a lag of a few seconds between button press and a change to the display.
Here's what the buttons do:
- Button 1: Cycle through the cryptocurrencies listed in config.yaml
- Button 2: Rotate Display -90 degrees
- Button 3: Invert Display
- Button 4: Cycle through the fiat currencies listed in config.yaml
Update frequency can be changed in the config.yaml file (default is 600 seconds).
To contribute, please fork the repository and use a feature branch. Pull requests are welcome.
- Video of the unit working here
- A low(er)-effort kit and frames can be obtained at https://veeb.ch/store
Some people have had errors on a clean install of Rasbian Lite on Pi. If you do, run:
sudo apt-get install libopenjp2-7
sudo apt-get install libqt5gui5
sudo apt-get install python-scipy
sudo apt install libatlas-base-dev
and re-run the script.
If the unit is freezing, try switching to another power supply.
GNU GENERAL PUBLIC LICENSE Version 3.0