Should the WireSock Virtual Adapter show as "unplugged?" #156
-
|
Is it normal the WireSock Virtual Adapter show as "unplugged?" It seems to be enabled properly in TunnlTo but Edge can't connect to internet while the tunnel is active and the virtual adapter shows as unplugged. |
Beta Was this translation helpful? Give feedback.
Replies: 2 comments 2 replies
-
|
TunnlTo doesn't utilise WireSock Virtual Adapter mode. It looks like you may have had WireSock installed manually prior to installing TunnlTo. I would suggest uninstalling WireSock from your system, and then following the WireSock installation prompt when you start TunnlTo. |
Beta Was this translation helpful? Give feedback.
-
|
I didn't install it, however when installing TunnlTo, it said that WireSock needed to be installed and offered to do it for me, which I clicked "yes" to |
Beta Was this translation helpful? Give feedback.
-
|
Sorry, I misinterpreted the original post.
Yep, that is normal for TunnlTo's usage of WireSock.
We will need further information to help diagnose this. Can you open an issue using the issue template for this please. |
Beta Was this translation helpful? Give feedback.
-
|
Ah ok, I wasn't sure if it was an issue so I posted in Q&A.. I'll do that then, thanks! |
Beta Was this translation helpful? Give feedback.
TunnlTo doesn't utilise WireSock Virtual Adapter mode. It looks like you may have had WireSock installed manually prior to installing TunnlTo. I would suggest uninstalling WireSock from your system, and then following the WireSock installation prompt when you start TunnlTo.