This is a P8X32A/Propeller, P2X8C4M64P/Propeller 2 driver object for the ENC28J60 10BaseT Ethernet Controller
IMPORTANT: This software is meant to be used with the spin-standard-library (P8X32A) or p2-spin-standard-library (P2X8C4M64P). Please install the applicable library first before attempting to use this code, otherwise you will be missing several files required to build the project.
- SPI connection at 20MHz W/10MHz R (P1), up to 20MHz (P2)
- Half and Full-duplex operation
- FIFO control: auto-increment pointer, manually set read and write pointers, set read and write regions within FIFO
- Frame control: Optional frame padding (none, 60, 64 bytes), maximum frame length
- Collision control: backoff, collision window
- Packet timing: inter-packet gap delay, (back-to-back and not, full and half-duplex independently)
- Interrupt flags: received packet, DMA operation, PHY link status, TX complete/error, RX error
- PHY control: LED modes, hysteresis, loopback
- Packet filtering: unicast, CRC check, pattern match, magic packet, hash table, multicast, broadcast
- Flow control: TX, RX
- Checksum offload
- Demo code utilises network-spin - WIP Networking protocols objects
P1/SPIN1:
- spin-standard-library
- 1 extra core/cog for the PASM-based SPI engine
P2/SPIN2:
- p2-spin-standard-library
| Processor | Language | Compiler | Backend | Status |
|---|---|---|---|---|
| P1 | SPIN1 | FlexSpin (6.9.4) | Bytecode | OK |
| P1 | SPIN1 | FlexSpin (6.9.4) | Native code | OK |
| P2 | SPIN2 | FlexSpin (6.9.4) | NuCode | Untested |
| P2 | SPIN2 | FlexSpin (6.9.4) | Native code | OK |
(other versions or toolchains not listed are not supported, and may or may not work)
- Very early in development - may malfunction, or outright fail to build
- Draft version - WARNING: Preliminary/unstable API
- Duplex is not advertised automatically by the chip; when switching between half/full duplex in the driver, the same must be manually configured on the remote node