VCVrack Modules
LFO module with two offset knobs which trims the top and bottom values from the LFO leaving the original waveform intact. Has the extra function of mixing the diffent waveforms when the offsets are left full, but those can be trimmed also. If you click click on the "RST" text under the RESET port it will manually reset the LFO. The result of this will also change the LFO's phase.
note: Two versions of the same module. A BPM value on the display and a Hz value on the display both are identical bar the display.
Polyphonic Sample and Hold and or Track and Hold. Control each connected channels params seperatly by increasing / decreasing channel number. Gate signal dictates the number of channels or there is a context menu item to override this, with override enabled the first gate channel sets the sample capture to each user set channel. Built in scale and offset for each channel, individual invert, polar pattern, sampling mode (S&H / T&H) and or the ability to sample internal or external sources per channel polyphonically.
Dual Mono Parametric EQ with built in VU peak meter to see if the signal is clipping. Pre/Post gain to VU meters (pre EQ / Post EQ). Listen to what frequencies are being processed by the EQ with the headphone switch. Swap L/R channels. Modulation Inputs for Gain, Frquency and Q.
Polyphonic Mono to Stereo Mixer with 2 Aux Bus mutes/solo for each channel, Sums channels to the output 4x4. Select which channels to use with the Ch. knob i.e. 1-4 is polyphonic channels 1-4.
Clamps an Audio or CV signal to the min/max positions on the knobs, signal will not go over the values set. Attenuverts the incoming signal clamp is applied to the output. The buttons on the attenuverted signal can quickly snap to a position. Gain is applied before the clamp, Note: hard clips the signal to the voltages set so it will start to distort the signal if the gain is set too high. can easily pad a 10v(0dB) to -0.1dB
Just like VCV Merge except 4 channels are always on, when there is no input connected you can open the signal so a voltage is sent or when off sends 0v. When there is an input connected you can mute the signal using the buttons or quick mute all by pressing the channel lights area, passes the connected inputs to the poly out. Best use on Poly Mix as you need to send a 1v signal to a level if there is a level mod on another channel on the chain. For pan mute the signal 0v (centre pan - mute) for level unmute the signal (open). Context menu for increasing number of channels
Sums polyphonic channels and distributes odd / even channel numbers.
Low Mid High, simple Attenuating EQ, Invert button to get rid or add some Muddiness. Use on a parallel channel on Poly Mix (connect to AUX) can sound good for kick drums.
Because 1 just is not enough.
You can find more information in the Wiki
If you would like contribute to development a donation would be very much appreciated, you can do so here