--tfan is not accurate on rtx3080

[LiGithubYu]

My setting is --tfan 50, the temperature is 51.6, the fan speed is 84% and don't add again.

[igoralebar]

it's not supposed to be "accurate"
this is done to prevent fan ramping up and down constantly to meet the target temperature
it won't adjust if whole value of temperature differs from target by only 1 degree

[LiGithubYu]

it's not supposed to be "accurate"
this is done to prevent fan ramping up and down constantly to meet the target temperature
it won't adjust if whole value of temperature differs from target by only 1 degree

51.6-50=1.6>1, that means removing the decimal?
Phoenixminer and t-rex are both more accurate.

[igoralebar]

yes, that what I mean by “whole value” gminer displays temperature without decimals, so whenever you see a temperature in gminer that is lower or higher by more than 1 degree, it will cause fan adjustment

…

On Tue, 18 May 2021 at 06:03, LiGithubYu ***@***.***> wrote: it's not supposed to be "accurate" this is done to prevent fan ramping up and down constantly to meet the target temperature it won't adjust if whole value of temperature differs from target by only 1 degree 51.6-50=1.6, it means removing the decimal? phoenixminer and t-rex are both more accurate. — You are receiving this because you commented. Reply to this email directly, view it on GitHub <#263 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ASZO6IZF23MXERAQH5IA5XLTOHKJVANCNFSM446YL3SA> .

[LiGithubYu]

yes, that what I mean by “whole value” gminer displays temperature without decimals, so whenever you see a temperature in gminer that is lower or higher by more than 1 degree, it will cause fan adjustment

Ok, thank you.