SW_CmdLine

Command line interface

piTelex provides a small funny command line interface which gives you access to the commands listed below.

Start the interface...

• by entering the command <ESC>cli<ENTER> at the terminal (module screen)
  Input rule for the commands: cmd<ENTER>

or

• by dialing '009' at the teleprinter / CCU
  Input rule for the commands: cmd<CR><LF>

Available commands:

cmd	Description
whoami	prints "pitelex-cli"
wru	prints software answerback, if configured
debug	prints configured debug level (deprecated)
ping	prints "pong"
ip	prints IPV4-address and hostname
port	prints configured i-telex port
dev	prints the names of the enabled devices and the associated software modules
exit	prints "bye", leaves the cmdline interface and turns the teleprinter off
	Linux only commands
ipx	prints IP information
cpu	prints cpu load
mem	prints memory usage
disk	prints disk usage
uptime	prints uptime since last reboot
w	lists logged in users