-
Notifications
You must be signed in to change notification settings - Fork 29
Build Guide: Using STM32 Board as Controller
HoanTV edited this page Nov 23, 2020
·
22 revisions
Images hasn't been implemented yet. Connection as the following: 1. Encoders:
A -> PA0
B -> PA1
Z -> PA2
2. Built-in DAC PA4 (PWM+) PA5 (PWM-) PE11 DIR
3. PWM
- PWM+- PE9, PE11
- PWM/DIR: PE9, PE11
- PWM0..50.100 PE9
4. Connection in detail
AASD (use PWM/Dir)
Peacemakers topic and change PE11 to PA4 if you want to use built-in DAC
Mige driver's guide has not yet completed
What is VNM Wheelbase Firmware?
Initial Configuration for an AASD-Based Setup
Build Guide: Using STM32 Board as Controller
Build Guide: Using VNM FFB Board as Controller
AASD Servo Drive Parameter Configuration and Calibration
AASD Servo Driver Parameters and Functions
Important Notes for Building the AASD Wheelbase
Assetto Corsa
rFactor 2