-
Notifications
You must be signed in to change notification settings - Fork 29
Important Notes for Building the AASD Wheelbase
karldink edited this page Nov 20, 2020
·
1 revision
Please take note of the following important information for an AASD-based wheelbase:
- The EStop button should be wired normally closed (NC) so that when it is engaged (pressed down) it opens the circuit. Only when racing and configuring will you disengage the E-Stop (which opens the circuit).
- This a safety feature that disconnects the motor if your E-Stop button is disconnected unintentionally. Upon disconnection, the circuit will open as if the button is pressed down (which disengages the motor).
What is VNM Wheelbase Firmware?
Initial Configuration for an AASD-Based Setup
Build Guide: Using STM32 Board as Controller
Build Guide: Using VNM FFB Board as Controller
AASD Servo Drive Parameter Configuration and Calibration
AASD Servo Driver Parameters and Functions
Important Notes for Building the AASD Wheelbase
Assetto Corsa
rFactor 2