Sonoff S31 based configurable Router / Modem rebooter with MQTT
- Power cycle's connected device on internet failure
- Publishes status udpates via MQTT and local web page
- Firmware upgradable via the Web Interface
WiFi SSID: RouterRebooter_XXXXXX
WiFi Password: routerrebooter
URL: 192.168.4.1
After it joins your wifi, find its IP and load it in your browser.
- MQTT Server and Topic base
- Test server and port
- Test interval
- seconds between test attempts
- Failure count before reset
- doesn't reboot on first failure )
- Success count to reset failure status
- allow recovery from temporary outage without restarting
- Minimum device on time
- prevent power cycling before device would normally have been online
- Device off-time
- How long to leave the device off to ensure a proper reset
- RouterRebooter/available
- online
- offline
- RouterRebooter/status
{"lastms": 20, "countFail": 0, "countSuccess": 0, "routerReset": 0, "epoch": 1585687912, "ip": "192.168.1.2", "rssi": "-34 dBm" }
- lastms = Last connection success time in milliseconds
- countFail = How many attempts have failed in this session - will reset to 0 if connectivity returns
- countSuccess = How many attempts have succeeded in this session - will only increment if previous failures detected and not reset to 0
- routerReset = If the router is getting ready to be rebooted
- epoch = Unix Epoch Time
- ip = IP address of the unit
- wifi = WiFi Network Name to which the device is connected
- rssi = WiFi Signal Strength for the device
- RouterRebooter/switch/cmd
- Set to 0 to reboot the connected device, will auto-turn back on
- RouterRebooter/esp/cmd
- Set to 0 to reboot the ESP module
- If you change your WiFi Network name, or otherwise need to reset the RouterRebooter to default settings:
- Slowly press the S31's power button 4 times inside of 5 seconds.
- Within 30 seconds, you should see the
RouterRebooter_XXXXXX
WiFi Network name again. - Re-connect and configure for your new WiFi network name.
- Once on your new WiFi network, connect and restore your desired settings.