-
Notifications
You must be signed in to change notification settings - Fork 3
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Question #1
Comments
You should be able to use what you have.
You might need to shorten a jumper to put your USBASP in programming mode.
Usually you find two holes on the buttom of the PCB that is used for this.
…On Sat, Oct 23, 2021, 02:58 tcpipchip ***@***.***> wrote:
Hi,
I have the Chinese USBASP.
To program the Chinese USBASP (update to PDI), will i need other
programmer to make this programming or i can i use the same to reprogram
it, as i do to the ST-LINK V2
thanks
—
You are receiving this because you are subscribed to this thread.
Reply to this email directly, view it on GitHub
<#1>, or unsubscribe
<https://github.com/notifications/unsubscribe-auth/ABB5QIN7OMMDVBGODYL6363UIICCDANCNFSM5GRU2PLQ>
.
|
Thank you so much! Is that make.hex in your GitHub already compiled to PDI ? I intend to use this programmer now with arduino to program the ATXMEGA32E, must i compile the AVRDUDE to be compatible with the ATXMEGA32E ? some tip to use this programmer with ARDUINO ? thanks again |
@nieldk |
you will need to put your usbasp in update mode, by shorting two pins.
On mine, look at picture.
You will need another programmer to do the update. Can be any that supports
the ATMega chip on your usbasp.
That could be another usbasp.
…On Mon, Oct 25, 2021, 00:14 tcpipchip ***@***.***> wrote:
@nieldk <https://github.com/nieldk>
Can you confirm if i want to acquire other USBASP to program my USBASP ?
—
You are receiving this because you were mentioned.
Reply to this email directly, view it on GitHub
<#1 (comment)>,
or unsubscribe
<https://github.com/notifications/unsubscribe-auth/ABB5QIOKPVLOQGMTKRO73H3UISANLANCNFSM5GRU2PLQ>
.
|
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Hi,
I have the Chinese USBASP.
To program the Chinese USBASP (update to PDI), will i need other programmer to make this programming or i can i use the same to reprogram it, as i do to the ST-LINK V2
thanks
The text was updated successfully, but these errors were encountered: