ddetoolboardpt1000thermistor

# klipper board use this 

[extruder]
step_pin: head0:PB3
dir_pin: head0:PB4
enable_pin: !head0:PB6
heater_pin: head0:PA6  # "HEAT"
rotation_distance :4.6715
microsteps: 16
nozzle_diameter: 0.800
filament_diameter: 1.750
sensor_type: PT1000
sensor_pin: head0:PA0 # "THERMISTOR"
pullup_resistor: 2200 # The board uses a 2.2k ohm pullup to work with a PT1000 
min_temp: 0
max_temp: 450
max_extrude_only_distance: 151.0
pressure_advance : .034
pressure_advance_smooth_time: .02
[tmc2209 extruder]
uart_pin: head0:PA10
tx_pin: head0:PA9
interpolate: True
run_current: 0.36
sense_resistor: 0.110
hold_current: 0.15
stealthchop_threshold: 0
driver_TBL: 0
driver_HEND: 3
driver_HSTRT: 2
driver_TOFF: 4
[heater_fan hotendtool]
pin: head0:PA8   # "FAN1"
heater: extruder
heater_temp: 50.0

[thermistor dyze500]
temperature1 : 25
resistance1 : 4500000
temperature2 : 200
resistance2 : 8070
temperature3 : 400
resistance3 : 253
#[verify_heater extruder]
#max_error: 180
#check_gain_time:
#hysteresis: 6
#heating_gain: 2