Assembling

The following images show the assembling process of the hardware components. The Amp+ was mentioned in the descriptions. Now I use Amp2 but the assembling process is the same for both.

1. The frame from the perforated sheets assembled. The power push-button and power supply installed and wired.

2. Raspberry Pi 3 and Amp+ installed and connected to the power supply.

3. Touchscreen installed.

4. The GPIO cable with soldered infrared sensor and rotary encoders connected to the Amp+ and to the touchscreen.

5. The speakers and passive radiators connected to the wooden case. The speakers connected to the Amp+.

6. The Rubber Feet attached to the wooden case. The screws which connect the rubber feet also connect the frame to the wooden case as well.

7. The back panel attached to the wooden case.

8. The front panel attached to the wooden case. Done!

<<Previous | Next>>