arduino-eeprom-programmer

Arduino EEPROM programmer written and tested for 28C256 EEPROM. Should work with any EEPROM given proper timings.

Features

• Manual rom write: Write single bytes with a interactive interface.
• Manual rom read: Read single bytes with a interactive interface.

Following modes are only meant to be activated by the client

• ROM file write: Send raw data in 64 byte blocks. Do not send more than 64 bytes. "O" means OK, "D" means done. Will exit after a certain timeout. Starts from address 0.
• ROM file read: Meant to be activated by the client. Send the number of bytes you wanna read. Arduino will reply with the data. Starts from address 0.

Important notes

• Do not send anything to arduino before running the client. Just plug in the arduino and run the client.

• It's really slow atm but I am going to implement paged write on arduino side when I feel like it