GBCTV Release 1.1.1

Changelog

• Replaced lots of magic numbers with named constants (irrelevant for actual usage but whatever)
• Added Gameboy Color detection and error message for incompatible devices
• Really minor performance improvements

GBCTV Release 1.1.0

Changelog

• Added signal profile switching
• Set recording target to SRAM rather than WRAM
• Changed MBC to MBC5 + RAM + BATTERY (out of necessity, duh)

GBCTV Release 1.0.0

The first of possibly a very small amount of further releases. Currently it can only store one signal profile at a time.

Instructions

Recording Signals

Press the A button once prompted to start an IR recording. The program waits for an incoming IR signal before starting the recording. If the small recording-dot icon disappears before any signal was provided there was most likely some sort of interference. In this case, just hit A again until it records the signal properly.

Note: Keep in mind that (currently) starting a new recording automatically overwrites any previous recordings.

Playing Back Signals

Pressing the B button (while no recording is in progress) starts playback of the last stored signal. Holding down the B button loops this signal over and over.

Note: Pressing B before recording any signals will end up sending random signals and may cause unintended side effects. I would recommend against doing this.