Repository navigation
Replies: 3 comments 1 reply
|
Thanks. Do you mean blocks clipped with XCLIP (a clipping boundary on the reference)? To find why these disappear I need the drawing, or a copy with only one of the missing blocks left in it, plus the OCS version you used. You can attach it here or open an issue with it. Generated by Claude Code |
|
Thanks for the drawing. I opened Block_Delim.dwg with the current main build: the clipped wall layers, insulation and anchors come out as in your AutoCAD screenshot, also with the drawing placed back at its original UTM coordinates. One cause of missing pieces was fixed in bd44aab: hatches and wipeouts inside a clipped block were cut against the clip boundary in single precision at absolute coordinates, which far from the origin is only good to about half a unit, so a clipped block smaller than that could lose its fill. Which OCS version did you use for the screenshot? Please check again with the next build and tell me if any block still disappears. Generated by Claude Code |
Uh oh!
There was an error while loading. Please reload this page.
Some delimited blocks disappear in OCS


All reactions