Repository navigation
v3.2.0.0
MLAstroRPA plugin 3.2.0.0
N.I.N.A. plugin for the MLAstro Robotic Polar Alignment hardware controller.
✨ Highlights
- mDNS Name in NETWORK CONFIG — a new group box renames the controller (the
.localtail follows the typed name). The name is sent to the device on SAVE ALL & REBOOT over Serial (MDns:) and over the wireless link (mdns_name) and read back from the telemetry, so the plugin can rename the device exactly like the Web UI does. - Hide polling telemetry on terminal — the CONNECTION tab can drop the
?poll and the telemetry line it answers with; the real commands and their replies stay visible. - The terminal logs whole lines — a telemetry frame longer than one COM read is shown as one complete line instead of two cut chunks.
🔧 Changes
- The handshake timeout is fixed at 300 ms (the input box is gone) and a failed handshake is reported as
Handshake: TIME OUT. - The connection / handshake status lines are coloured by what they say: green for connected or handshake OK, orange for disconnected, red for a connect failure or a handshake time out.
- HARDWARE SETTING: one title size for every section and sub-section, the sub-sections (AZ/ALT Limits, AZ/ALT Motor, mDNS Name, Access Point, Station Mode) are group boxes, and the Configuration Management buttons sit on one row at their natural width.
📦 Assets
MLAstroRPA_Plugin_3.2.0.0.msi— installer: the plugin 3.2.0.0 plus the bundled TPPA DLL
SHA256:1887CF819E99055167CC8D132FA6FFC0A4F76BB20EEFBBBB24C0D54F0DACBDF6NINA.Plugins.MLAstroRPA.dll— plugin 3.2.0.0 onlyNINA.Plugins.PolarAlignment.dll— the TPPA build bundled with this release
🛠 Install
- Close N.I.N.A., run the MSI (it installs the plugin and its TPPA companion), or copy the DLLs into
%LOCALAPPDATA%\NINA\Plugins\3.0.0\MLAstroRPA\and...\Three Point Polar Alignment\.
⚠️ Notes
- The mDNS name needs firmware 1.11.0 or newer over Serial (
MDns:) and 1.10.0 or newer over Wireless (mdns_name). - The bundled TPPA DLL still reports version
2.2.8.0(same number as the previous build).