Skip to content

2D Editor Guide

André Borchert edited this page Aug 22, 2026 · 11 revisions

2D Editor Guide

The 2D plan is where you lay out walls, openings, furniture and lights. The top of the plan is north (0°). All measurements are centimetres.

Tools

Tool Key What it does
Select V click to select; drag walls, openings, furniture
Wall W drag to draw a wall (90° only, snaps to the grid)
Door D click a wall to add a door, then drag to slide it
Window G click a wall to add a window, then drag to slide it
Erase E click anything to remove it
Measure M drag between two points for a distance readout
Furniture sidebar / F click the floor to place; R turns 90°
Light sidebar 60 W bulb or 200 W office panel, mounted on the ceiling
Public sidebar drag a rectangle to mark shared floor space

Grid and snapping

Pick 1 / 2 / 5 cm in the toolbar. Walls snap to the grid, to room corners and to other wall endpoints; a green dot marks the snap and a chip shows the live length while you drag.

Tip — draw on 5 cm to rough a room out, then switch to 1 cm to fine-tune a single wall. The grid only affects new input, never what you already drew.

Walls

Axis-aligned only. Drag an endpoint to resize, the middle to move the whole wall. Walls shorter than 30 cm are discarded.

Where two walls meet, RoomCAD extends each end across its neighbour so the corner is one solid piece in 3D — free-standing ends keep exactly the length you drew.

Doors and windows

  • Slide an opening along its wall. Chips show the distance on both sides: to the wall ends and to the neighbouring opening.
  • Set an exact position or width in the inspector instead of dragging.
  • Doors are open by default. Double-click a door (or right-click → Close door) to toggle it; the inspector sets which way it swings.
  • Widths clamp to 60–140 cm (doors) and 40–200 cm (windows), and an opening always keeps 10 cm of wall at each end.

Furniture and lights

Ten pieces: bed, table, chair, wardrobe, desk, sofa, bookshelf, nightstand, dresser, armchair.

  • While you drag, the item turns green where it fits and red where it would hit a wall or another item. Flush against a wall (0 cm) is allowed; overlapping is not.
  • Chips show the gap to the nearest wall and the nearest other item.
  • Arrow keys nudge the selection by one grid step.
  • A light is a fixture, not furniture: it mounts under the ceiling and may sit above furniture. The 60 W bulb hangs on a cord; the 200 W panel is a recessed 60 × 60 cm office fitting.

Public areas

Public marks floor that belongs to everyone — a corridor, a living room. It is drawn as a green rectangle and, importantly, the automatic layout leaves it alone.

Automatic floor layout

In the inspector, set rooms (how many) and target m² each, optionally tick windows, then Generate:

Public areas ──► kept as-is
Everything else ──► split into N rooms by recursive cuts
                    + one door per room
                    + one window per room (outside-facing walls only)

Redesign produces a different but equally balanced variant. Each run is a single undo step, so ⌘Z takes you back to the previous design.

View

Action Control
Zoom mouse wheel (centred on the cursor), or the − / + buttons
Zoom to a value double-click the percentage and type one
Preset zoom 100%, 200%, Fit
Pan hold Space and drag, or drag with the middle mouse button
Turn the plan 90° ⌘[ / ⌘] — labels stay upright

Undo, redo, delete

⌘Z / ⇧⌘Z, or the toolbar arrows. ⌫ deletes the selection, Esc clears it. A drag is one undo step, not fifty.

Clone this wiki locally