Skip to content

Getting Started

André Borchert edited this page Aug 22, 2026 · 4 revisions

Getting Started

Nothing to install — RoomCAD runs in the browser. This page builds one real room from scratch, then saves it.

1. Log in

Open the site and enter the shared password. A cookie keeps you logged in on that browser, so you only do this once.

The password identifies the project. A browser opening RoomCAD for the first time lands on the project's most recent saved design; after that it always comes back to the exact design and version you last worked on.

2. What you see

┌──────────────────────────────────────────────────────────┐
│  2D Plan │ 3D Walk │ grid │ tools │  New · Save · Open   │  toolbar
├──────────┬───────────────────────────────┬───────────────┤
│ My Rooms │                               │  Inspector    │
│ Build    │        the plan               │  (whatever is │
│ Furniture│                               │   selected)   │
└──────────┴───────────────────────────────┴───────────────┘

Both dividers are draggable, and RoomCAD remembers the widths.

3. Worked example: a 4 × 3 m bedroom

Start from + New Room, then:

# Do this Result
1 In the inspector set Width 400, Length 300 a 4 × 3 m shell
2 Toolbar → 5 cm grid comfortable snapping
3 Press D, click the bottom wall a door, 90 cm wide
4 Drag the door sideways chips show the gap to each wall end
5 Press G, click the top wall a window at 90 cm sill height
6 Sidebar → Bed, click near a corner green = it fits, red = it clashes
7 Press R the bed turns 90°
8 Sidebar → Light → 60 W Bulb, click the middle a ceiling bulb
9 Press ⌘2 walk it in 3D
10 Press L in the 3D view daylight off — see the bulb work

Anything went wrong? ⌘Z undoes, ⇧⌘Z redoes.

4. Save

Click 💾 Save. The room is stored on the server as ternak_room1, ternak_room2, … and every save creates a new version — nothing is ever overwritten. The status bar confirms Saved as ternak_room3 · v7.

To go back in time, open 📂 Open…, pick a room, then choose a version from the list.

⬇️ Export downloads the same design as a .rcad file you can keep or re-import later.

5. Work together

If someone else is in the project, a green Join Live button appears. See Live Collaboration — it is deliberate, not automatic.

Where next

  • 2D Editor Guide — every tool, including Measure, Public areas and the automatic floor layout.
  • 3D Walkthrough — physics, sun position and floors.

Clone this wiki locally