Created by RobSmithDev Based on the MNT ZZ9000 Network Driver by Lukas F. Hartmann and uses bits I learnt from reading how PlipBox works.
This is an implementation of a SANA-II driver for the Amiga, that will use the BlueScsi V2 WIFI version to give internet access to the machine! This code is based on the MNT ZZ9000Net driver by Lukas F. Hartmann (which is based on work by Henryk Richter) and also borrows a little from the PlipBox device by, well, theres several people.
For a step-by-step guide on installing, check out (this video by Retronaut)[https://www.youtube.com/watch?v=FDtqd04bq-k]
This requires the latest BlueSCSI V2 firmware in order to work.
I've tested it with the following setups:
- A590 HDD (2M fast ram, 7.0 ROM)
- Blue Scsi V2 Wifi version
- Kickstart 3.2
- Impact A2000-HC+8 Series II (8M Fast Ram)
- Blue Scsi V2 Wifi version
- Kickstart 3.1
The hdd light constantly flashes while the driver is in use. The driver needs to be copied to the Devs:Networks folder and then setup your TCP/IP stack as normal.
If you find your data transfer is very slow, like less than 5k/s then check you've turned the debug log off within BlueSCSI!
scsidayna.prefs contains an example config file for the device. This needs to be copied to ENVARC: on the Amiga and rebooted. If you change this file, they will not be picked up until restart or you copy it to ENV: The format of that file is:
DEVICE=scsi.device
DEVICEID=-1
PRIORITY=0
MODE=1
AUTOCONNECT=0
SSID=
KEY=\
where:
- DEVICE is the name of the SCSI driver, eg: scsi.device or gvpscsi.device
- DEVICEID is the SCSI device index the DaynaPORT is on, or -1 for Auto Detect
- PRIORITY -128 to 127, sets the I/O task priority, see below
- MODE see below
- AUTOCONNECT 0/1 if 1, the driver will attempt to connect to the WIFI device (you can configure BlueSCSI to do this)
- SSID The SSID/Wifi name to connect to if autoconnect=1
- KEY the wifi key/password
This patches around weirdness in the various SCSI drivers. Mode should be:
- 0: This runs in normal mode
- 1: Runs in 24-byte pad mode (required for scsi.device - A590/A2091)
- 2: Runs in 'single transfer' mode (required for gvpscsi.device)
This needs to match the SCSI interface you're using. You can check this using HDToolbox (see what device it uses in the tool type) or SCSIMounter etc.
A small note about task priority. If left at 0 the device will function perfectly fine, however the throughput of data is somewhat all over the place. If you want a really stable throughput, then set this to '1', but also expect this will possibly slow down some of the other applications running on your system.