v0.8.3 — privacy fix & 0.8 UI

0.8.3

• Privacy: removed every screenshot containing real device names, IPs, paths or session titles; rewrote the 0.8.x history so the old commits are unreachable from main. Sample data in the design draft now uses placeholders.
• UI: session desk with a device rail, whole-row selection, on-demand selection bar with target menu, bottom transfer dock, and shared panel/host settings.
• 0.8.1: row actions no longer overlap the status chip; the concurrent-transfer setting now explains auto (cap 5) vs manual 1–16.
• npm: @xxgxiaoyu/dsh-session-sync@0.8.3 (the unscoped name belongs to another project).
• Tests: 60 passing; CI green.

No screenshots are attached to this release.

v0.7.1 — device column overflow & full list ｜ 设备列不再溢出、多少台都显示

中文说明

修复设备列的两个可见问题（截图反馈：设备只看到 3 个、右侧 ⋯ 按钮压到会话栏）。

• 不再溢出：.ss-shell / .ss-side / .ss-device-item 统一 box-sizing:border-box，⋯ 按钮回到列内，不再跨过 16px 间隙压住右侧卡片。
• 多少台都显示：设备列自身滚动（max-height: min(60vh, 560px)），不做截断；新增说明「列表展示全部已发现或曾连接过的设备；其他网段可在『网络与高级』里加网段扫描」。
• 为什么只有 3 台：列表长度等于宿主实际发现的设备数。UDP 广播不跨路由器，其他网段的机器需要在那里填网段（如 192.168.5.0/24）或 IP:端口，保存后会立刻重新扫描。
• 新增测试：渲染 30 台设备并断言 30 行全部存在。

English

Two visible problems in the device column fixed (from the screenshot: only 3 devices listed, and the row's ⋯ button bleeding into the session pane).

• No more overflow: box-sizing:border-box on the shell, column and rows — the ⋯ button stays inside the 340px column instead of crossing the 16px gap.
• Nothing is truncated: the device column scrolls (max-height: min(60vh, 560px)), and a new hint says every discovered or previously seen device is listed, with other subnets scanned from “Network & advanced”.
• Why only 3: the list length equals what the host has actually discovered. UDP broadcast does not cross routers, so machines on other subnets need a subnet (e.g. 192.168.5.0/24) or ip:port there; saving rescans immediately.
• New test: renders 30 devices and asserts all 30 rows exist.

Tests: 59.