Repository navigation
Increasing simulation time with respect to max-density #646
Unanswered
abbasebriastro
asked this question in
Q&A
Replies: 0 comments
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Uh oh!
There was an error while loading. Please reload this page.
Hi dear user,
In the simulation I am running, I initially started without imposing any control over the maximum density. However, after about 5 time units, I observed that due to the simulation being run at very high density, certain divergences occurred, such as "h|divB|/B is too large", and the simulation stopped.
To prevent this density overestimation and to maintain the system in an isothermal state, I applied rho_final. However, what happens is that when the simulation reaches this density, it stops.
When I set rho_final so that the number density reaches the order of 10^10 cm⁻³, I observed that the simulation stopped as soon as it reached this density value. The corresponding time was approximately 5.61 (in code units), whereas I was aiming for an evolution up to 14.75 (in code units).
Now, I am unsure which part to adjust and how to extend the simulation time while ensuring that the density is not overestimated (beyond 10^10 cm⁻³). If I focus on the desired time, the density is not maintained, and if I focus on the density to prevent overestimation, then the time is lost. I am unable to adjust it properly.
Best,
Abbas.
All reactions