Hardware_versions

tommie edited this page Nov 15, 2014 · 13 revisions

ESP-01, Versions 1 and 2

Info

For enabling the chip in the second version, bind pin CH_PD to VCC (3.3v).

Pins to chip names

Pin Name Description
1 GND Ground
2 U0TXD UART0 Transmit
3 GPIO2 Has internal pull-up
4 CHIP_EN Chip Enable, active high
5 GPIO0 Has internal pull-up
6 EXT_RSTB External reset signal, active low, has no pull-up? Spurious blue LED activity when attaching a DMM between GND and RST to check voltage.
7 U0RXD UART0 Receive, has internal pull-up
8 VDD +3.3V power input

LEDs

Color Name Description
Red PWR Tied to VCC, so always on when power is applied
Blue TXD UART TX indicator, tied in hardware to U0TXD

ESP-03

Info

Starting the module bind CH_PD to VCC (3.3v) and GPIO15 to GND

ESP8266MOD

References

You can’t perform that action at this time.
You signed in with another tab or window. Reload to refresh your session. You signed out in another tab or window. Reload to refresh your session.
Press h to open a hovercard with more details.