ESP32 devkit V1 not working!

[Maxime66410]

Board

ESP32 DevKitV1

Device Description

esp32-wroom-32

Hardware Configuration

Just plugged in pc with USB.

Version

latest master (checkout manually)

IDE Name

Arduino IDE

Operating System

Windows 10

Flash frequency

40Mhz

PSRAM enabled

no

Upload speed

115200

Description

My ESP 32 Devkit V1 don't work.

It's been two weeks since I touched them, it's new and in very good condition.

When I tried to go back to it it didn't work at all.

So when I turn it on no led, no detection on the pc, no communication port on.

If I keep pressing EN a red led stays on until I stop pressing.

Sketch

Don't have any sketch.

Debug Message

Don't have any message.

Other Steps to Reproduce

No response

I have checked existing issues, online documentation and the Troubleshooting Guide

• I confirm I have checked existing issues, online documentation and Troubleshooting guide.

[SuGlider]

It sounds like a hardware or an USB cable problem.
You should see, at least, the Red ON indicator LED when the board is connected to the PC using an USB cable.

Can you test it with a different USB Cable?
Do you have another board to test it?

[SuGlider]

[SuGlider]

[Maxime66410]

Hello, I have already tested with other cables but also on several different connections.
Also the led does not turn on.
It activates only if I press EN and when I release nothing.

[SuGlider]

Hello, I have already tested with other cables but also on several different connections. Also the led does not turn on. It activates only if I press EN and when I release nothing.

It sounds like a hardware/board problem to me...
Is your board the same as in the pictures above?

[me-no-dev]

could also be that USB-UART drivers are not installed

[SuGlider]

My concern is that @Maxime66410 says that not even the ON LED turns on. It only turns on when EN is pressed.
Is it right @Maxime66410?

[Maxime66410]

could also be that USB-UART drivers are not installed

They are installed. ☹

[Maxime66410]

My concern is that @Maxime66410 says that not even the ON LED turns on. It only turns on when EN is pressed. Is it right @Maxime66410?

Right !

[SuGlider]

@Maxime66410 - The default behavior of the board is to turn on the ON LED as soon as it is connected to the PC, using the USB Cable. Pressing EN shouldn't affect this LED.

As I said, I think this ESP32 board may have some problem.
In that case there is nothing we can do to help you...