arduino-esp32 as a component on SD card via SPI failure

[kungfupizza]

Board

ESP32S3 Wroom N8R2

Device Description

SPI connected to SD Card for Wroom esp32s3

Hardware Configuration

My pinout:
MOSI / DI IO13
MISO / DO IO14
CLK IO15
CS IO16

Version

latest development Release Candidate (RC-X)

IDE Name

ESP-IDF

Operating System

Windows 11

Flash frequency

240Mhz

PSRAM enabled

yes

Upload speed

115200

Description

I am using esp32-arduino as an IDF component. I have SD card on SPI, it initialises file but on reading a file, i can see it reading for a while then failing with

[E][sd_diskio.cpp:132] sdSelectCard(): Select Failed
[201932][E][sd_diskio.cpp:630] ff_sd_status(): Check status failed
[202440][E][sd_diskio.cpp:132] sdSelectCard(): Select Failed
[202445][E][sd_diskio.cpp:630] ff_sd_status(): Check status failed
[202951][E][sd_diskio.cpp:132] sdSelectCard(): Select Failed
[202956][E][sd_diskio.cpp:630] ff_sd_status(): Check status failed
[203464][E][sd_diskio.cpp:132] sdSelectCard(): Select Failed

Sketch

SPIClass spi = SPIClass(FSPI);
esp_err_t sd_card_init( void )
{
    // init from pins
    spi.begin(PRJ_CONFIG_SDCARD_SCK, PRJ_CONFIG_SDCARD_MISO, PRJ_CONFIG_SDCARD_MOSI, PRJ_CONFIG_SDCARD_CS);
    if(SD.begin(PRJ_CONFIG_SDCARD_CS, spi, 10000000) == false){
        ESP_LOGE(TAG, "Failure in SD card init");
        return ESP_FAIL;
    }
...
}

### Debug Message

```plain
[ 20376][E][sd_diskio.cpp:132] sdSelectCard(): Select Failed
[ 20381][E][sd_diskio.cpp:630] ff_sd_status(): Check status failed

Other Steps to Reproduce

No response

I have checked existing issues, online documentation and the Troubleshooting Guide

• I confirm I have checked existing issues, online documentation and Troubleshooting guide.

[lbernstone]

You need to test with a minimal example. SD card is known to work. If you have made changes to your sdkconfig, you need to post those changes.

[kungfupizza]

sdkconfig attached.
sdkconfig.txt

[lbernstone]

You have hundreds of differences between the arduino sdkconfig and yours. Start from the known good config and make your changes to that.

[VojtechBartoska]

did you solve your problem @kungfupizza?

[VojtechBartoska]

Hello, closing as Expired due to no answer.