imx8mm use ESP32-WROOM-32E module, Driver loading error

[mengleia]

cpu: imx8mm
system: linux kernel 6.1.36
esp driver: ESP-Hosted-NG_release_v1.0.2
esp-hosted: latest commit 5042106

insmod esp32_sdio.ko error

mmc log

esp_log.txt
kernel_log.txt

[mantriyogesh]

• @kapilkedawat

[kapilkedawat]

@mengleia Please make sure the connections are correct, and that the pull-up requirements are met.
https://docs.espressif.com/projects/esp-idf/en/latest/esp32/api-reference/peripherals/sd_pullup_requirements.html

[mengleia]

@mengleia Please make sure the connections are correct, and that the pull-up requirements are met. https://docs.espressif.com/projects/esp-idf/en/latest/esp32/api-reference/peripherals/sd_pullup_requirements.html

Thank you for your reply
I have Burn the flash voltage selection eFuses and pull-up resistor to GPIO12, Our hardware has already met the requirements pull-up, But it's still the same error.

I see an example of using imx8mm. Do you have any relevant configuration references？

[mengleia]

@mantriyogesh
mmc device log

insmod esp32_sdio.ko ---> esp32_sdio: probe of mmc0:0001:1 failed with error -110
Please tell me how to analyze the problem？

[mantriyogesh]

1. Setup schematic and picture, please?
2. I also suspect you are using release binary with latest master, which may not be compatible.
   It is better to use same version either side.

• 2.1 So if you wish to use release,
  
• 2.2 Else you can use latest master both sides (ESP and host) (Suggested)
  • Flash ESP32 from sources (Check the documentation how to do it)
  • Use latest master code at Host for building

[mengleia]

@mantriyogesh
thank you for your reply, I have successfully loaded the driver.
the dts cannot use "non-removable" options.

[mantriyogesh]

Try broken-cd